E-BI
KE S
YSTEM - E100 S
ERI
ES
E-BI
KE S
YSTEM - E100 S
ERI
ES
16
17
OPERATING THE SYSTEM VIA DISPLAY
Turning the System On/Off
Hold the M button will turn the e-bike system on. Hold the M
button to turn the display off. When powered off, the unit uses very
minimal power.
Changing the Level of Pedal Assistance
The default setting for the display is 1. You can vary the level
of assistance by using the + and - buttons from 0 (no pedal
assistance) to 5 (maximum pedal assistance).The level of
assistance is indicated at the top of the display.
Walk Assist Mode
To engage walk assist mode, hold down the – button. The bike
will begin moving at 6km/hr – useful for when walking the bike up
hills. Releasing the button will stop the walk assistance.
Turn on lights
Hold the + button down until the light led is illuminated. The
display is dimmed whilst the lights are activated so as not to blind
the rider whilst in low light conditions
Changing Modes
To change between modes, press the M button. Pressing the M
button toggles between average speed and current speed and also
between trip meter and Odometer. You can see which you have
selected on the left hand side of the display.
Battery Capacity
There is a battery capacity indicator at the bottom of the display
measured in 5 increments
Error Code
When there is a fault with the system, the E light will be displayed,
along with the corresponding code.
BATTERY CHARGER
• Only use the charger provided with the kit
• The LED light on the charger indicates the function of charger.
• When the light is flashing, it is charging the battery. When it is
complete it turns green.
SPECIFICATIONS
Efficiency - Over 80%
Temperature – low operating temperature
Input – 220-240 VAC 50-60Hz 90W
DC Output – 36V 2A
MOTOR
• The motor is a brushless sealed (geared) drive unit that does not
require maintenance.
