Access Point Configuration
3-4
c.
Enter
no ip dhcp
to disable DHCP.
d.
Set the IP Address. Enter
ip address
ip-address netmask gateway
,
where
ip-address
is the access point’s IP address,
netmask
is the network
mask for the network, and
gateway
is the default gateway router. Check
with your system administrator to obtain an IP address that is compatible
with your network.
After configuring the access point’s IP parameters, you can access the
management interface from anywhere within the attached network. The
command line interface can also be accessed using Telnet from any
computer attached to the network.
e.
Go to Step 4.
4.
Change the default username and password. Enter
username
and specify a
unique user name; enter
password
and specify a unique password.
RoamAbout 4102(if-ethernet)#no ip dhcp
DHCP client state has changed. Please reset AP for change to
take effect.
RoamAbout 4102(if-ethernet)#exit
RoamAbout 4102#reset board
Reboot system now? <y/n>: y
Username: admin
Password:********
RoamAbout 4102#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 4102(config)#interface ethernet
Enter Ethernet configuration commands, one per line.
RoamAbout 4102(if-ethernet)#
RoamAbout 4102(if-ethernet)#ip address
ip-address netmask
gateway
RoamAbout 4102(if-ethernet)#end
RoamAbout 4102(config)#
RoamAbout 4102(config)#username JohnBL
RoamAbout 4102(config)#password ******
Confirm new password: ******
RoamAbout 4102(config)#
Summary of Contents for RoamAbout RBT-4102-BG
