Connecting the K-POE-4BAY PoE Shelf to a K-Series Chassis
3-2 Installing a Power Supply
Connecting the K-POE-4BAY PoE Shelf to a K-Series Chassis
Use a K-POE-CBL-2M cable to connect a K-Series AC power supply installed in a K-POE-4BAY
PoE shelf to a K-Series chassis.
You can connect up to two K-Series AC power supplies to a K10 chassis for PoE power. You can
connect a single K-Series AC power supply to a K6 chassis for PoE power.
To connect a K-Series AC power supply to a K-Series chassis for PoE power:
1.
Remove the cover from the recessed PoE connector at the rear of the K-Series chassis. See
If you are connecting two power supplies to a K10 chassis, remove the covers from both PoE
connectors.
Figure 3-1 Removing the Cover from the PoE Connector on a K-Series Chassis
Table 3-1 Contents of K-Series AC Power Supply Carton
Item
Quantity
K-Series AC power supply
1
For USA shipments: NEMA power cord 5-15,C13
Type of power cord is dependent on country of installation.
1
WEEE notice card
1
Documentation notice card
1
Note:
You must purchase the K-POE-CBL-2M cable separately. Ensure that you purchase and
install one K-POE-CBL-2M cable for each power supply that you plan to install in the K-POE-4BAY
PoE
shelf.
