Page 10 of 14
AVN-AN-MGMT-R10
Installing the Management Interface Card
Application Note
Installing and Configuring the Management Interface Card
Replace the Cover
In order to replace the cover, reverse the three steps in the section “Remove the
Cover” on page 4.
1.
Set the cover as shown in Figure 7. Place the front of the cover about 1/2 inch
behind the front edge of the chassis.
2.
Make sure the sides of the cover are inside the sides of the cabinet. The slots
on the cover fit over the mounting screw inserts on the side of the chassis and
allow the cover to seat itself on top of the chassis sides.
If the cover does not seat in the chassis sides, the slots are not aligned with the
screw inserts. Move the cover (back or forward) accordingly to allow the
cover to seat itself.
3.
Push the cover forward until the screw holes align themselves. See Figure 5.
Re-install ANG-3000/7000 series In the Rack
Refer to the section “Removing the ANG-3000/7000 series from the Rack” on page 3,
and reverse the steps to re-install the ANG in the rack. Reconnect the Ethernet cables
to the back of the ANG.
The RJ-45 management interface connector location is show in Figure 16.
Figure 16
Management Ethernet Connector Location
Management connector
Aurorean
Network Gateway
External Ethernet
Trusted Ethernet
