Using the RESET Button
4-6
Troubleshooting
4.3
USING THE RESET BUTTON
The RESET button shown in
Figure 4-2
is located on both the 5G102-06 and 5G106-06 modules.
The button is used to reset and re-initialize the module.
Figure 4-2
RESET Button
To reset the module processor, press and release the RESET button. The module goes through a
reset process for approximately 60 seconds. Additional downtime may result as the module
reenters the network.
CAUTION:
Pressing the RESET button resets the device, and all current switching
being performed by the module is halted. A module downtime of up to two minutes will
result from this action for any devices connected to the module.
NOTE:
Pressing the RESET button while the module is already in reset mode is not
recommended. If the RESET button is pressed while the module is in reset mode, the
module will enter an extended diagnostic procedure, which is unnecessary for normal
operation. This extended diagnostic procedure takes longer than one minute to
complete.
RESET
COM
1
CPU
Gb ENET
5G106-06
RESET Button
35871_07
