8500-6
Model 5230/6230 Video Audio DAC
INSTALLATION
6230 Submodule Installation
The optional 6230 Audio Processing submodule installs on the component side of the 5230
Video Processing module circuit board. If the option is ordered with the 5230 module, it
will come already installed.
To install the 6230 Audio submodule, locate the three connectors on the left side of the
circuit board as shown below and line the connectors up, checking the alignment. Press
carefully into place to seat the submodule.
5230 Video Processing Module
Plug the 5230 module into any one of the slots in the 1 RU or 3 RU frame and install the
plastic overlay provided onto the corresponding group of rear BNC connectors associated
with the module location. Note that the plastic overlay has an optional adhesive backing
for securing it to the frame. Use of the adhesive backing is only necessary if you would
like the location to be permanent and is not recommended if you need to change module
locations. This module may be hot-swapped (inserted or removed) without powering down
or disturbing performance of the other modules in the system.
CABLING
Refer to the 3 RU and 1 RU backplane diagrams of the module on the following page for
cabling instructions. Note that unless stated otherwise, the 1 RU cabling explanations are
identical to those given in the 3 RU diagram.
6230 Audio Processor
6230 Submodule Installation
