Enraf Nonius Curapuls 670, Manual

Page: 44 / 204

ENGLISH
EN109-1670750-46 IFU
Page 10 of 34
C
ONNECTION TO MAINS SUPPLY
Plug in the device to a wall socket using the mains cable.
The flashing dot in the upper display [9] indicates that the unit is connected to the mains
supply and is on stand-by.
To disconnect the device:
•
Switch off the device using on/off button [4].
•
Unplug the device from the wall socket.
T
RANSPORT
C
ONDITION
When moving the device from one room to another,
please make sure the electrode arms are folded in
with the Circuplodes close to the device.
The push handle is designed to push the device.
Be careful not to tip the device over when pulling it.
To remove the cable from the electrode, make certain the power is off.
While the electrode is being supported by the electrode arm, hold the electrode while
removing the cable to prevent the electrode from dropping to the floor.
Tighten electrode arms so that they do not move during therapy.
Observe the patient and the position of the electrode arms at all times during therapy.
Inform the patient that the electrode arms are not supposed to move during therapy.
Before using the unit, verify the patient is not in contact with the unit, the electrode
connection cable, the electrodes, or other devices or metal objects.
Use of any other cable other than the supplied cable is strictly PROHIBITED as it
affects patient safety and the proper function of the device.
Make certain that the unit is electrically grounded by connecting only to a grounded
electrical service receptacle conforming to the applicable national and local electrical
codes.