- 12 -
6) Fix Charger
7) Connect Cables
The power supply cables go through the input inlet at the charger's bottom, and connect to the corresponding
PE, L1, L2, L3 and N terminals on the breaker inside charger. A network cable is needed to connect the
charger with the EN-GATE which has an access to the Internet by Ethernet. One end of the network cable
connects to the charger's CAN port on the PCBA. Through the CAN inlet at the charger' bottom, the other end
of the network cable connects to the EN-GATE's CAN port. Details about EN-GATE installation refer to its
user manual. L1, L2, L3 also correspond to R, S, T phases.
Wall-mount Installation:
Fix the charger to the bracket by mounting
two screws to two screw holes at the bottom
of the charger and bracket.
Floor-stand Installation:
Fix the charger to the pillar by mounting four
screws to four screw holes at the bottom of the
charger and on top of the pillar.
