Repeater-EnO868SELV
EnOcean Repeater 868 MHz
Repeater-EnO868USB
Read the operating instructions carefully before commissioning.
Installation and operating instructions
Rev.: February 2016
Repeater-EnO868_104126_OperationManual_E_FEB2016.doc/pdf
Page 2 of 7
BootUp GmbH
|
Sonnenbergstrasse 23
|
CH-5236 Remigen
|
Switzerland
|
Phone +41 56 284 09 21
|
Fax +41 56 284 09 22
2016
|
Omi technical changes excepted
|
www.BootUp.ch
|
www.myHomeControl.ch
|
Safety / Legal regulations
The device is only intended for its intended use. An unauthorized conversion or change is prohibited!
The following points should be considered:
•
The applicable laws, standards, regulations and the state of the art at the time of installation.
•
The manuals of the radio transmitters and receivers..
•
The instruction manual can only give general instructions. These have to be seen in connection with a
specific application.
Specified proper operation: The duty cycle of 1% per hour must be observed for this device!
Caution!!
This device
may not be used
in conjunction with devices that, directly or indirectly, serve human,
health, or life-saving purposes, or that could cause danger to people, animals, or property.
Do not leave the packing material carelessly, plastic foil / bags, etc., could be a dangerous toy for children.
Disposal: Do not throw old devices into the trash!
Dispose the device according to the laws and standards of the country in which the device is
operated! The device contains electrical components that must be disposed as electronic waste.
The housing is made of recyclable plastic.
BootUp products (Repeater-EnO868USB, Repeater-EnO868SELV) comply with the R&TTE Directive
1999/5/EC and comply with EU regulations. The products may be sold and operated free of registration and toll-
free in the countries of the European Union, the CH, IS and N.
Installation instruction
The designer plastic housing is prepared for direct surface mounting (wall or ceiling). The housing does not
have to be opened for mounting. The device can be hung in screwed-in screws. Two blind holes at a distance of
55 mm are provided on the underside of the device. The screws should not be thicker than 4 mm and the screw
head should not be larger than 6 mm.
Please note that the device is designed for indoor use only. Do not mount in places that can be sprayed directly
with water! Wipe clean with a damp cloth only.
For optimal placement of the device and radio range, please refer to the information "Radio ranges between
transmitters and receivers" on the next pages.
The ideal installation place (best radio range) is located in rooms about 1 m below the ceiling. The distance to
other transmitters (e.g. GSM / DECT / Wireless LAN / EnOcean transmitters) should be at least 2 m.
Note:
NEVER mount the transmitter unit in a metal enclosure or near large metal objects. An installation near
the ground or on the ground is not recommended.
Commissioning
The device is connected to the power supply via the connecting cable and is thus in operation. Any
configuration or teach-in is not required. The power is supplied via appropriate lines.
For the USB Repeater via a USB power adapter by inserting the USB Type A plug.
With the SELV Repeater by connecting to the power supply. It is important to pay attention to correct polarity.
Repeater GND (black) on UP6 black, re UB (red) on UP6 red.
The green <Power> LED lights up as soon as the device is powered. A special "learning procedure" between
transmitter and repeater is not necessary. Each received radio signal is indicated by the yellow LED <Radio>.
The appropriate repeater mode can be activated via the switch.
