A.
Fasten slide guides to the side of
CD-ROM (DVD or 5.25" FDD)
using fine thread flat head screws
(Fig 7).
B.
Slide CD-ROM in to 5.25" bay and
snap in to place (Fig 8).
Fig:5
Fig:6
Fig:7
Remove fan housing by using thumbs to
unfasten clips and place fan in housing (Fig 5).
Snap fan housing back into the chassis.
Connect fan and speaker wiring to M/B as
instructed in M/B user manual
(After M/B is installed!).
Install 3.5" HDD and FDD (floppy)
A.
Squeeze tabs on sides 3.5"
drive cassette (Fig.6) and pull
out to remove. Slide HDD into
cassette and fasten with coarse
thread flat head screws.
B.
Slide floppy into the same
cassette and fasten with
fine thread flat head screws.
Install CD-ROM, (DVD or 5.25" FDD)
Fig:8
Series EN-7230
Remove screws and slide right side
towards you 1" and lift up (Fig. 3).
Remove the left side in the same
way. Lift top panel and remove
from hooks as shown (Fig 4).
One pc. Cover
Remove screws and slide
cover towards you 1".
Spread sides and lift
vertically to remove.
Fig:2
Fig:4
***Important
-First please check your model number before proceeding. The user
manual is set up to correspond to the model number and installation will vary
depending on the model.
Required tools:
Phillips head screwdriver, pliers
***
(Photos shown may vary according to model number)
Place case on edge of table. (Fig.1)
With 1 hand holding top of chassis,
pull in quick motion from the bottom
of the bezel to remove it (Fig. 2). Be
careful not to pull bezel off before
hinges are disengaged.
**Note-
it might require some force
to remove due to the snug fit to the
chassis.
Fig:1
Fig:3
