GB
- 29 -
rotation of the disc. If you work in the other
direction there is the risk of kickback. The
device may be forced out of the cut.
Always switch on the device before placing
it against the workpiece. After cutting or
grinding, always lift the device from the
workpiece before switching it off.
When working, always hold the device
securely with both hands.
Always keep proper footing and balance.
For the best grinding performance move
the device evenly to and fro over the
workpiece maintaining an angle of 30° to
40° (between grinding disc and workpiece).
When working on inclined surfaces, do not
press the device hard down on to the
workpiece. If the speed slows greatly, use
less pressure. This will allow you to work
more effectively and safely. If the device
suddenly stops due to it becoming
retarded or trapped, pull the mains plug
from the socket immediately.
Cutting: Advance the device at an appro-
priate rate. Do not incline the cutting disc.
Grinding and cutting discs get hot during
use – allow them to cool fully before
touching them.
Never use the device for a purpose for
which it was not intended.
Before you insert the mains plug into
the socket, always check that the device
is switched off.
If a dangerous situation arises, pull the
mains plug immediately out of the mains
socket. Ensure that the device and the
mains plug are easily accessible and can
be reached quickly in an emergency.
When taking a break from your work,
before carrying out any tasks on the device
itself and when you are not using the
device, always pull the mains plug out of
the mains socket. Always keep the device
clean, dry and free of oil or grease.
4. Proper use
The angle grinder is designed for grinding or
cutting metal and stone when using the
appropriate grinding or cutting wheel and
guard.
Caution! To cut metal and stone the angle
grinder may only be used when the guard
(available as an accessory) is mounted.
The machine is to be used only for its pre-
scribed purpose. Any other use is deemed to
be a case of misuse. The user / operator and
not the manufacturer will be liable for any
damage or injuries of any kind caused as a
result of this. Please note that our equipment
has not been designed for use in commercial,
trade or industrial applications. Our warranty
will be voided if the machine is used in com-
mercial, trade or industrial businesses or for
equivalent purposes.
5. Technical data
Mains voltage: ................... 230-240 V ~ 50 Hz
Power input: ............................................. 900 W
Idling speed: ................................. 12.000 min
-1
Max. wheel diameter: ............................. 125 m
Wheel thickness: ................................... 1.7 mm
Mounting spindle thread: .......................... M14
Protection class: .........................................II /
Remain alert at all times! Always watch
what you are doing and proceed with
caution. Do not use the device if you cannot
concentrate or you are feeling unwell.
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
LpA sound pressure level .............. 91.3 dB(A)
KpA uncertainty ......................................3 dB(A)
LWA sound power level ................ 102.3 dB(A)
KWA uncertainty .....................................3 dB(A)
