46
Place the dust container on the power base by first placing it on the latch at the bot-
tom of the power base and then close it until you hear the release button click into
place.
NOTICE!
Possibility of damage to the appliance!
Inserting the filter incorrectly may damage the
appliance.
Before using the appliance for the first time,
ensure that the dust filter has been inserted
correctly in the dust container.
Cleaning the suction opening
After a while, dirt and dust can collect around the suction opening and can reduce the
vacuum power. To avoid this, the suction opening should be cleaned regularly.
Switch off the appliance.
Remove dust and dirt on and in the suction opening.
Carefully remove the flap on the end of the nozzle and clean it.
Replace the flap again.
Storage
Store the appliance on the wall bracket (see section „Mounting the wall bracket“ on
page 42).
When you do not intend to use the appliance for a longer period of time, disconnect
the mains plug from the socket and store the appliance in a dry, dust-free and frost-
free environment that is not exposed to direct sunlight.
TROUBLESHOOTING
If the appliance stops working properly, please refer to the troubleshooting table shown
below to see if you can resolve the problem yourself.
Never attempt to repair the appliance yourself. If a repair is necessary, please contact our
Service Centre or a suitable authorised repair workshop.
Problem
Solution
The vacuum cleaner is
not working
Battery is not sufficiently charged
The suction power is re-
duced
Dust nozzle is blocked. Switch off the appliance. Re-
move blockage.
Dust filter/cyclone attachment is dirty. Clean the dust
filter/cyclone attachment.
Dust container is full and must be emptied.
19400 ML Eurospin IT Content 5006 5664 Final_rev3.indb 46
19400 ML Eurospin IT Content 5006 5664 Final_rev3.indb 46
02.10.2020 09:10:18
02.10.2020 09:10:18
