EN
26
hook (6) locks into place properly. And open the
locking hook (6) to remove the motor head (3).
◊
Fitting the castors (Fig. 5)
Fit the castors (13) into the appropriate
mountings on the underside of the tank (7).
◊
Fitting the foam filter (Fig. 6)
For wet-vacuuming, slip the supplied foam
filter (15) over the filter basket (4).
◊
Assembling the dirt bag (Fig.7)
For vacuuming fine, dry dirt, it is recommended
to use the dirt bag (14). Slip the dirt bag (14)
over the vacuuming hole. The dirt bag (14) is
suitable for dry-vacuuming only.
◊
Attaching the suction hose (Fig. 8 & 9a-9c)
Connect the suction hose (10) with 3-part
suction tube (11) and combination nozzle (12)
or crevice nozzle (16) according to the desired
use, then attach the suction hose (10) to the
corresponding connector on the wet and dry
vacuum cleaner.
5. Operation
Switching on/off
1. Press the On/off switch (2) in position “I” to
switch on.
2. Press the On/off switch (2) in position “O”
to switch off.
Nozzle usage
Crevice nozzle (16) for vacuuming gaps,
corners and radiator.
Combination nozzle (12): for wet and dry
vacuuming of smooth surfaces and fitted
carpets. Hide the brush by choosing the
selector switch(26) when cleaning carpets to
get the better suction result.
Wet vacuuming
1. Remove the dirt bag (14).
2. Put on the foam filter (15) on the filter
basket (4).
3. Suctioning up the water.
4. Empty the tank (7) immediately after
vacuuming because it is not designed to
store water.
5. If the tank (7) is full, the safety float valve
(5) closes the suction opening, and the
vacuum operation is interrupted. Switch off
the appliance and empty the tank (7).
Dry vacuuming
1. Attach the dirt bag (14), and remove the
foam filter (15).
2. Use the proper nozzle to vacuum the dusts.
Suction function
◊
To perform the suction, insert the suction
hose (10) into the suction hose connector
(8) on the motor head (3). (Fig.8)
◊
Following the above vacuuming instruction
for suction function.
Blowing function
To blow, plug the suction hose (10) onto the
blowing connector (9) on the motor head (3).
6. Clean and maintenance
WARNING!
Risk of injury. Always switch the appliance off
and remove the battery pack before carrying
out any work on the appliance.
• Repair and servicing work not described in
this manual should always be carried by our
service center. Use only original parts and
accessories.
• The appliance must always be kept clean,
dry and free from oil or grease.
• Use a soft, a slightly moist cloth to clean
the housing and the waste container.
• Always clean the appliance and waste
container after completion of work.
• Never permit any liquids to enter inside
the appliance. Never use petrol, solvents or
cleansers which can damage the plastic.
• Never hose the appliance down with water.
• Always empty the water immediately after
use.