EN
25
4. Before use
Unpacking
1. Unpack all parts and lay them on a flat
stable surface.
2. Make sure the delivery contents are
complete and free of damage. If you find
that parts are missing or show damage,
do not use the product but contact your
dealer or the service center. Do not use the
product unless missing parts have been
delivered in addition or defective parts
have been replaced. Using an incomplete or
damaged product represents a hazard to
people and property.
3. Ensure that you have all the accessories
needed for assembly and operation.
Charging the battery pack
Note
◊
The battery can be damaged in case of
improper charging.
◊
Remove the charger's mains plug before
inserting or removing the battery.
The battery is partially charged upon delivery to
avoid damage to the battery caused by a deep
discharge. Prior to initial start-up and when the
battery is low, the battery should be charged.
To do so, please proceed as follows:
1. Slide the battery pack (19) onto the
charger (18) upside down till it locks in
place.
2. Insert the mains plug of the charger (18)
into a properly fused mains socket. The RED
charge control LED (25) is illuminated; and
charging requires approx. 60min.
3. Wait until the RED charge control LED
(25) goes out and GREEN charge control
LED (24) is illuminated, the battery is fully
charged.
4. Hold onto the mains plug while pulling
the power cable of the charger out of the
mains socket. The battery pack (19) and
the charger (18) may have become warm
during charging, allow the battery cool
down to room temperature.
5. Take the battery pack (19) out of the
charger (18) by pressing and holding the
battery release button (20) and pulling the
battery pack (19) out of the charger (18).
Removing /Inserting the battery (Fig.10)
1. To remove the battery pack (19) from
the tool, press the battery release button
(20) on the battery pack (19) and pull the
battery out.
2. To insert the battery pack (19), place it on a
guide track and push it back into the tool. It
will audibly snap in.
Checking the battery charging level (Fig.11)
The battery comes with an integrated battery
level indication.
The battery status is displayed as follows by the
three LEDs of the battery level indication (LED)
(22).
LED color
Meaning
Green-Orange-Red
Maximum charge/
power
Orange-Red
Medium charge /
power
Red
Weak charge –
Recharge the battery
Press on the battery charge level button (23)
on the battery pack (19). You can read the
battery status from the battery level indication
(LED) (22).
Assembly
WARNING!
Remove the battery before carrying out any
work on the appliance (e.g. maintenance,
changing, etc.) as well as during the transport
and storage of the appliance. Unintentional
activation of the trigger can result in injury.
◊
Fitting the motor head (Fig. 1 & 4 )
The motor head (3) is fastened to the tank (7)
by the locking hook (6), make sure the locking