EN
27
2. Insert the dust-free bit into the SDS tool
holder (1) with a twisting motion until it
latches.
3. The drill bit locks itself. Check the locking by
pulling on the tool, and make sure the tool
is attached securely.
4. For removing, pull the locking collar (3)
backwards and pull out the drill bit.
Auxiliary Handle
WARNING!
Always switch the product off and remove the
battery pack before carrying out the work on
the product.
1. Slide the auxiliary handle (8) onto the
hammer and rotate to the desired working
position.
2. To clamp the auxiliary handle (8), rotates
the handle clockwise.
3. To loosen the auxiliary handle (8), rotate
the handle anti-clockwise.
Adjustable depth gauge
Fit the drill bit into the chuck. Loosen the
adjustable depth gauge (16) by rotating the
handle anti-clockwise. Slide the depth gauge
(16) until the distance between the depth
gauge end and the drill end is equal to the
depth of hole/screw you wish to make. Then
clamp the depth gauge (16) by rotating the
handle clockwise.
5. Operation
Switch on and off
●
Switch ON : Press the on/off switch (5) to
start : and the LED light (10) is luminated
●
Switch OFF: Release the ON/OFF switch (5)
to stop, and the LED light (10) turns off.
Adjusting the rotation speed
Press the ON/OFF switch (5) lightly for a low
speed. Increasing the pressure can increase
the speed. Pressing to the deepest is the
highest speed.
Switch lock
The switch trigger can be locked in the OFF
position when placing the forward and reverse
rotation control (6) in the centre position. This
helps to reduce the possibility of accidental
starting when not in use.
Setting the rotation direction
WARNING!
Operate the forward and reverse rotation
control (6) only when the product is at a
standstill.
With the drill pointing away from you, push
the forward and reverse rotation control (6) to
the left for forward rotation; push the forward
and reverse rotation control (6) to the right for
reverse rotation.
Function mode selection:
WARNING
Changing the function mode only when the
product is at a standstill. Otherwise the tool
could be damaged
●
Use the function mode selector (4) to
select the operating mode.
●
To change the operating mode, turn the
function mode selector to the desired
position.
Hammer drilling= hammer ON
Drilling only = hammer OFF.
6. Cleaning and maintenance
WARNING!
Risk of injury. Always switch the product off
and remove the battery pack before carrying
out any work on the product.
●
Repair and servicing work not described in
this manual should always be carried by our
service center. Use only original parts.
