ENGLEFIELD
DURACYL WALL
INSTALLATION INSTRUCTIONS
Page 6
Carefully
measure and mark pattern
on wall
board surface as shown in
figure 9
.
This pattern applies to:
NOTE:
Measurements from edges, top and
base. All dimensions below are in millimeters.
• Flat shower wall
• Side contour shower wall
• Flat bath wall
DURACRYL WALL INSTALLATION CONT...
30
50
30
250
300
80
Adhesive
Pa
tter
n
Pattern on wall board
Adhesive
Pa
tter
n
Pattern on wall liner
Pattern on wall board
Pattern on wall liner
W
all Liner position already marked
Tray recess
Tray recess
CORNER
CORNER
Fig.9: Adhesive pattern for Flat & Side Contour
MARKING ADHESIVE PATTERN
For corner contour shower walls, the pattern must be marked on both wall board
and
Duracryl liner.
Refer to
fi
gures below for both patterns: • Corner Contour PLUS Wall -
• Corner Contour Wall -
At this stage it is essential that the back side of the Duracryl wall and the surface of the wall board
are wiped clean with a damp cloth. This will ensure that all dust is removed from both surfaces and
provide a clean surface for the adhesive. Allow both surfaces to dry before adhesive application.
Fig.10: Adhesive pattern for Corner
Contour PLUS Walls
30
50
30
250
300
80
Adhesive
Pa
tter
n
Adhesive
Pa
tter
n
W
all Liner position already marked
CORNER
CORNER
Fig.11: Adhesive pattern for Corner
Contour Walls
Mark the pattern but
do not apply adhesive
at this stage.
!
IMPORTANT
30
30
80~100
Pattern on wall board
Adhesive
Pattern
W
all Liner position already marked
Tray recess
CORNER
