Hardware Installation
A. Remove the two screws on the back of the enclosure
with a Philips screwdriver.
B. Loosen the four screws on the surface of the unit.
These screws will be used later to minimize the gap
between the heat sink and your hard drive.
C. The plastic bracket should slide out effortlessly. Insert
your hard drive, connect the IDE or SATA cable and
the power cable from the enclosure accordingly.
Please ensure that your hard drive jumper setting is
configured at Master.
D. Secure your hard drive to the bracket with the four
screws that are included in the package.
E.
Reverse the procedure by re-inserting the bracket to
the aluminum casing and
F.
securing all the screws that was previously removed.
Congratulations, you have completed the hardware
installationm,
-2-
