►
►
►
►
►
►
►
►
►
►
►
►
►
►
►
►
►
Shutting Down
&Clean Up
Winterizing &
Long-Term Storage
Maintenance Instructions
If detergents have been used, insert 1
gallon of fresh water into Detergent
Tank. Siphon water at low pressure for
one minute to clear the line of residual
detergent.
Move the engine stop switch to the
OFF position. Close the fuel valve.
Turn off the water source.
Press trigger to release water pres-
sure.
Release trigger and engage gun safety
lock.
Disconnect the garden hose from the
water inlet on the unit.
Disconnect the high pressure hose
from the high pressure outlet. Store
the high pressure hose in the gun
holder assembly.
It is highly recommended to use a
small amount of antifreeze before
winter storage and during the cleaning
season to protect the pump from freez-
ing and premature wear.
Turn engine switch to the OFF position
Disconnect all hoses.
Unscrew cap from Pump Guard bottle.
Remove internal seal.
Reattach cap to Pump Guard bottle
and remove black protective cap.
Screw bottle into water inlet on pres-
sure washer pump and squeeze.
With ignition OFF, pull starter rope until
fluid starts to exit.
Unscrew bottle. Store or dispose prop-
erly.
If Guard is unavailable, perform the
following:
Disconnect all water connections.
Turn on the machine for a few
seconds, until the water which
remained in the pump exits. Turn off
engine immediately.
Failure to follow the above directions
may result in damage to the pump
assembly and accessories and void
the warranty.
Do not allow high pressure hose to
become kinked.
Store machine and accessories in a
room which does not reach freezing
temperatures. DO NOT store near
furnace or other sources of heat as it
may dry out the pump seals.
Pump Inspection
You should routinely make a visual
inspection of the pressure washer’s
pump.
Pump
11
