Engelmann Sensor GmbH, Rudolf-Diesel-Straße 24-28 , 69168 Wiesloch-Baiertal, Germany
Phone.: +49 (0)6222-9800-217 , Fax: +49 (0)6222-9800-50, E-Mail: [email protected], www.engelmann.de
Article-No. 1080700010 - 2011-04-01
Engelmann
T h e h e a t m e t e r s p e c i a l i s t s
®
Page 6
–
Check that the connections are tight.
–
Screw the cable glands tight by hand.
Connection for 4-wire technique
Connection for 2-wire technique
10.2 Connection of optional interfaces
•
The following are options that the calculator can be equip-
ped with at the factory (state when ordering) and will vary
depending on the individual calculator.
•
Feed the cable to be connected (cable diameter Ø 3.5 to 6.5
mm) through an opening on the bottom edge of the calcula-
tor housing into the space containing the terminal strips.
•
The terminal clamps are designed to
fi
t strands with ends
with a cross-section of 0.5 – 1.5 mm
2
.
•
Clamp on the cable according to the following illustrations
that apply depending on the interface.
Depending on the option,
here there are located two
additional pulse inputs (IN)
for further meters or two
pulse outputs (OUT) for
connection to an additional
system.
For connection of meters
with open collectors atten-
tion must be paid to the
polarity.
Polarity is not important for
these connections so the wires
can be clamped arbitrarily.
When the M-bus network is in
operation a triangle will appear
in the lower right corner of the
display.
(Power supply from the M-bus
network is functioning.)
Connection of M-bus
Connection of pulse outputs or inputs
Connection of power pack
It is strongly recom-
mended to use only the
Engelmann Sensor
power pack.
It is imperative to pay
attention to the polarity
Important note: The fl ow sensor is not powered by the
power pack!
Attention: Please check the unused cable glands to make
sure that the necessary blind plugs are inserted
and then tighten the cable glands by hand.
•
Check that the connections are tight.
•
The power pack should only be connected to 230V and
checked by authorized technical personnel.
•
Check on the display whether a
triangle appears in the lower right
corner, as shown in the illustration.
•
Screw the cable gland tight by hand.
•
Close the cover of the calculator housing and protect
against unauthorized opening using the delivered
Optional
:
For the dual-purpose heat/
cooling meter version, sepa-
rate pulse outputs for heating
energy and cooling energy
are available.
