ENGCOM S1-S3, Instruction Manual

Page: 12 / 40

12
Instruction manual
4 Assembly and installation
Check that the necessary supplementary documentation is available before starting
assembly. Your supplied tilt mounting and supplementary documentation are adapted
as far as possible to your base machine.
The below assembly and installation instructions only apply to direct mounting of the
tilt mounting. If the tilt mounting is mounted onto an implement hitch, you should use
the base machine’s manual for connection of implements.
4.1 Connecting the tilt mounting
Before starting assembly
1. Check the limits for tipping load. The tilt mounting’s
weight and the increased reach might make it necessary,
for instance, to reduce the bucket volume.
CAUTION
Check the limits for tipping load when connecting
the tilt mounting and implement hitches, to mini-
mise risk of accidents.
Faulty installation can be dangerous. If in any
doubt about your knowledge or the equipment,
contact your dealer or engcon Nordic AB.
Risk of catching in moving parts. Risk of personal
injury.
2. Place the base machine and tilt mounting on a fl at,
non-slip surface. Make sure the tilt mounting is standing
straight and is aligned with the stick and dog bone (see
Figure 4).
3. During installation, use a ladder or other equipment that
does not cause risk of falling.
Figure 4