ENGBO AS
–
et selskap i Engbo-gruppen
BESØKSADRESSE
: Wirgenesvei 7, 3157 Barkåker
POSTADR
: Postboks 2288 Postterminalen, 3103 Tønsberg
WEB:
www.engbo.no
TLF:
+47 33 00 31 50
FAKS:
+47 33 00 31 60
38
Line guide
– adjusting the tension spring
The
line guide
is spring-loaded and
intended to press on the rope to ensure
sufficient friction between rope and gypsy.
If the spring becomes over-stretched, it may
be necessary to replace it. (Alternatively,
the spring
can be shortened slightly).
NB
It is important that the line guide
does not press too hard on the rope.
Too much friction between the rope
guide and the rope may prevent the
anchor from dropping at the required
speed.
The rope guide should be able to
move easily and freely above the
hinged bolt
when the spring is not
fitted. Only then will the spring be
able to exert the required pressure
on the rope guide.
Winter storage
Remove the rope from the windlass before every period of winter storage. Soak it in a
mild soap solution overnight. Then wash it in soapy water and rinsing fluid to rinse out
all the salt residue and dirt. This will keep the rope flexible for many years. At the
same time, check the wire thread auto stop indicators and replace them if necessary.
Before winter storage, spray the windlass and all electrical points and connections with
a moisture repellent spray.
Make sure that the windlass is protected against snow and water during winter storage.
Do not wrap the windlass, as this may cause condensation to form during winter
storage.
It is also a good idea to wash the inside of the rope box and remove seaweed, dirt, etc.
