ENGBO AS
–
et selskap i Engbo-gruppen
BESØKSADRESSE
: Wirgenesvei 7, 3157 Barkåker
POSTADR
: Postboks 2288 Postterminalen, 3103 Tønsberg
WEB:
www.engbo.no
TLF:
+47 33 00 31 50
FAKS:
+47 33 00 31 60
32
Fitting Maxi 34-H
The Maxi 34-H is designed to be fitted hanging below a
horizontal surface – for example, by fitting the bracket
below the deck. The Maxi 34-H is available with the line
wheel on the right or left-hand side of the windlass, as
seen from the rear.
NB
Make sure to fit the windlass correctly in relation
to the direction of rotation of the line wheel. (See
sketch)
Make sure that the opening to lead the rope through
the hull is positioned correctly in relation to the
direction of the rope. To prevent unnecessary wear,
the rope should not touch the edge of the opening
either vertically or horizontally. The opening should be
oval (top to bottom) to accommodate the play in the
rope roller when the windlass is used.
NB
Make sure to position the windlass correctly in
relation to the rope roller so that the windlass line
wheel and the roller are in line.
Once you have made the opening for the rope in the
stern, you can install the windlass. Run the anchor
rope tightly between the rope roller on the bathing
platform and the track in the line wheel. Hold the
windlass in position inside. This makes it easier to
establish where the windlass is to be placed to ensure
the rope sits correctly in the opening in the stern.
Once you have found the correct position, mark
around the windlass fixing bracket before removing
the windlass. Use the fixing bracket as a drilling
template. Use a 9 mm bit to drill the holes, and then
fit the windlass.
NB
If you are to use a rope conduit with guide pulleys
(68-00008), you can use the internal frame of the
conduit as the template for the opening.
If necessary, use an intermediate panel between the
windlass and the supporting surface to adjust the
windlass correctly in relation to the opening in the
hull. After final adjustment of the windlass position,
tighten the bolts.
Run the rope via the line wheel on the windlass, down
through the rope/chain guide and under the line
wheel. Use the windlass to wind it up.
