ENGBO AS
–
et selskap i Engbo-gruppen
BESØKSADRESSE
: Wirgenesvei 7, 3157 Barkåker
POSTADR
: Postboks 2288 Postterminalen, 3103 Tønsberg
WEB:
www.engbo.no
TLF:
+47 33 00 31 50
FAKS:
+47 33 00 31 60
10
Holder for wireless remote control
The enclosed, handy holder (12-47030), keeps the
wireless remote located in the right place when not in
use.
The holder kit consists of two single parts, and the holder
to and the bracket.
Slide the holder into the bracket by the slots.
Fix the bracket to the base with the adhesive tape.
By turning the backside of the remote forward and
fit it in the holder, the buttons will be protected
from unwanted activating of the winch or thruster
when kept in the pocket.
Installation
– general
The windlass should be positioned as high as possible to allow maximum space for the rope
that will be stored below the windlass. The height from the bottom of the well where the rope
is stored to the bottom edge of the line wheel should be
at least 50 cm
, and the
area
should be at least 40 x 40 cm
to allow room for 50 m x 15 mm anchor rope. This will
prevent the rope from bunching under the windlass, and assure sufficient friction between the
line wheel and the rope.
See the specific descriptions for the separate windlass models.
The anchor bracket
Fit the windlass so that the rope is wound up in line with the anchor bracket (see pictures 1
and 2) – numerous different models are available – positioned on the exterior of the boat. The
anchor bracket functions as a guide for the rope when the anchor is on the seabed and as a
“seating point” for the anchor once it has been raised.
