®
●
Up to 500 ft. range
●
Operate on 11-24VAC/DC
1
●
Code learning
●
FCC compliant
●
Fixed code or CODEBUMP
TM
code-hopping
Models Available
SK-910RAQ ..........
1-channel mini-receiver, 3A Form “C” relay, 315MHz
SK-910RAVQ ........
1-channel mini-receiver, 5A transistor ground output, 315MHz
SK-910RAV2Q ......
2-channel mini-receiver, 3A transistor ground outputs, 315MHz
SK-910RA-4Q .......
1-channel mini-receiver, 3A Form “C” relay, 433.92MHz
SK-910RAV-4Q .....
1-channel mini-receiver, 5A transistor ground output, 433.92MHz
SK-910RAV2-4Q ..
2-channel mini-receiver, 3A transistor ground outputs, 433.92MHz
More RF receivers are available (1 to 4 channels). Contact SECO-LARM for details.
SK
SK
SK
SK
SK-910RA
-910RA
-910RA
-910RA
-910RAQ SERIES
Q SERIES
Q SERIES
Q SERIES
Q SERIES
Miniature RF
Miniature RF
Miniature RF
Miniature RF
Miniature RF
R
RR
RReceivers
eceivers
eceivers
eceivers
eceivers
Installation Manual
ENFORCER
®
1
All models work on 11-24VAC/DC, except for the low voltage versions.
SK-910RAQ Shown
Introduction
These mini RF receivers are compatible with both code hopping and fixed-code transmitters (see page 4 of this manual
for a list of compatible transmitters). They can be used for a variety of applications, such as allowing the same transmitter to
arm/disarm a vehicle alarm and open/close a garage door opener. The receivers come in one- or two-channel versions.
Each channel can learn the codes of up to 15 different transmitter buttons on a first-in, first-out basis.
Installation Notes
1. Mount out of sight in a location where it is not surrounded by metal, and where it is not exposed to the weather or
moisture. Metal will block the RF signal, resulting in a reduced range.
2. For best range, pull the antenna wire as straight and high as possible. If the receiver receives interference from local
RF activity (eg., airport or military base), the antenna wire can be folded. DO NOT CUT THE ANTENNA WIRE.
