1000 TVL Camera On-Screen Display Manual
SECO-LARM
U.S.A., Inc.
16
WARRANTY:
This SECO-LARM product is warranted against defects in material and workmanship while used in normal
service for three (3) years from the date of sale to the original customer. SECO-LARM’s obligation is limited to the repair
or replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM. This Warranty is void
if damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair or alteration,
improper or abnormal usage, or faulty installation, or if for any other reason SECO-LARM determines that such equipment
is not operating properly as a result of causes other than defects in material and workmanship. The sole obligation of
SECO-LARM and the purchaser’s exclusive remedy, shall be limited to the replacement or repair only, at SECO-LARM’s
option. In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential personal or property
damage of any kind to the purchaser or anyone else.
NOTICE:
The information and specifications printed in this manual are current at the time of publication. However, the
SECO-LARM policy is one of continual development and improvement. For this reason, SECO-LARM reserves the right to
change specifications without notice. SECO-LARM is also not responsible for misprints or typographical errors.
Copyright © 2014 SECO-LARM U.S.A., Inc. All rights reserved. This material may not be reproduced or copied, in whole or
in part, without the written permission of SECO-LARM.
SECO-LARM
®
U.S.A., Inc.
16842 Millikan Avenue, Irvine, CA 92606
Website: www.seco-larm.com
PIKHR1
Phone: (949) 261-2999 | (800) 662-0800 Email: [email protected]
MiEV-C1303-NMGQ-OSD
_141024.indd
Nothing appears on the screen.
• Check the power cable, power supply output, and video
connection between the camera and monitor.
The image on the screen is dim.
• Clean the camera lens / lens glass with a soft clean cloth.
• Adjust the monitror controls as required.
• If the camera is facing a very strong light, change the camera
position.
• Adjust the lens focus.
The image on the screen is dark.
• Adjust the contrast control of the monitor.
•
If there is an intermediate device, correctly set the 75Ω/Hi-z.
The camera is not working properly
and the surface of the camera is
hot.
• Check that the camera is correctly connected to an appropriate
regulated power source.
Motion detection is not activated.
• Check that MOTION DET has been set to ON in the Setup
Menu.
•
Check that the MD AREA has been properly defined.
The color of the picture is not
correct.
• Check the settings in the WHITE BALANCE menu.
The image on the screen flickers.
• Make sure that the camera isn’t facing direct sunlight or
fluorescent light; if necessary, change the camera position.
SENS-UP does not work.
• Check that the AGC setting in the EXPOSURE menu isn’t set to
OFF.
• Check the EXPOSURE menu and make sure SHUTTER is set
to AUTO.
Troubleshooting:
