ENFORCER Voice Dialer
16
SECO-LARM U.S.A., Inc.
Dialer will not arm/disarm
Try re-entering the PIN number to ensure that you have
entered it correctly.
While pressing and holding the [PROG] button, use a pen or
paper clip to press the [RESET] button on the back of the
dialer. This sets the PIN number to the default (000).Then try
to arm/disarm again.
Dialer will not dial out
Make sure that the telephone line is working.
Make sure that you have programmed at least one
telephone number into the unit and that the full number has
been stored.
Make sure that the system is in Auto Dial mode.
Ensure that the line to the wall jack is plugged into the
dialer’s “LINE” jack, and any phone extension connected to
the dialer is plugged into the dialer’s “TEL” jack.
Unit doesn’t respond to a call-
back
Check to see if another unit (fax or answering machine)
could be answering the call and remove the other unit.
Adjust the call-in ring detect setting so the dialer will answer.
Difficulty in activating ‘room
monitor’ by telephone remote
control
Try pressing the code key again.
Move to a quieter location as ambient noise may affect the
dialer’s ability to detect the tone signal.
Troubleshooting:
NOTICE:
The SECO-LARM policy is one of continual development and improvement. For that reason,
SECO-LARM reserves the right to change specifications without notice. SECO-LARM is also not responsible
for misprints. All trademarks are the property of SECO-LARM U.S.A., Inc. or their respective owners.
Copyright © 2017 SECO-LARM U.S.A., Inc. All rights reserved.
SECO-LARM
®
U.S.A., Inc.
16842 Millikan Avenue, Irvine, CA 92606
Website: www.seco-larm.com
Phone: (949) 261-2999 | (800) 662-0800 Email: [email protected]
IMPORTANT:
Users and installers of this product are responsible for ensuring this product complies with all
national, state, and local laws and statutes related to monitoring and recording audio and video signals.
SECO-LARM
will not be held responsible for the use of this product in violation of any current laws or
statutes.
NOTE:
While the system can provide valuable protection to home and property when properly installed, it
cannot guarantee complete protection against intrusion. SECO-LARM is not responsible for any losses or
damage which may occur during the use of this product.
®
PIHLK1
MI_E-921CPQ_171002.docx
WARRANTY:
This SECO-LARM product is warranted against defects in material and workmanship while
used in normal service for one (1) year from the date of sale to the original customer. SECO-LARM’s
obligation is limited to the repair or replacement of any defective part if the unit is returned, transportation
prepaid, to SECO-LARM. This Warranty is void if damage is caused by or attributed to acts of God, physical
or electrical misuse or abuse, neglect, repair or alteration, improper or abnormal usage, or faulty installation,
or if for any other reason SECO-LARM determines that such equipment is not operating properly as a result
of causes other than defects in material and workmanship. The sole obligation of SECO-LARM and the
purchaser’s exclusive remedy shall be limited to the replacement or repair only, at SECO-LARM’s option. In
no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential personal or
property damage of any kind to the purchaser or anyone else.
