Enforcement Technology Group ETG-WRAPS-SYS, Operation Manual

Page: 10 / 12

TRANSCEIVER BASE STATION PROGRAMMING CHANNEL GROUPS &
OPERATING MODES
The WRAPS
™
System’s Transceiver Base Station features (2) Programming Channel Groups:

Programming Channel Group #1

Programming Channel Group #2
Each Programming Channel Group supports the connection of up to (3) Remote Transceiver Packs.
The Remote Transceiver Packs delivered with a WRAPS
™
System are preset at the factory to the Transceiver Base
Station’s Programming Channel Groups as follows:
Remote Transceiver
Belt Pack #
Transceiver Base Station
Programming Channel Group #
1 1
2 1
3 1
4 2
5 2
6 2
The Transceiver Base Station’s operating mode setting determines which Remote Transceiver Packs can
communicate with one another.
When the WRAPS
™
System’s Transceiver Base Station is powered on, it defaults to
“ Dual‐Channel ” operating mode.
When the Transceiver Base Station is set to “ Dual‐Channel ” operating mode, ONLY the Remote
Transceiver Packs that are set to the SAME Programming Channel Group (either #1 or #2) can
communicate with one another.
To allow ALL Remote Transceiver Packs to communicate with one another, the Transceiver Base
Station MUST be set to “ Conference ” operating mode.
To set the Transceiver Base Station to “ Conference” operating mode, press the device’s green
“ CONFERENCE ” button. NOTE: The red LED located on the front of the Transceiver Base Station
will turn on when the device is set to “ Conference ” operating mode.
Pg. 9 of 11 Ops Ver. 03/18
Transceiver Base Station
“CONFERENCE” Button
(Conference Mode Active)