Integration Guide
Draft
EDG0208IG001
Page 36
Rev. 1.03 –4/19/07
6.7.13
Transmit Active Output (Pin-37)
Logic-output that signals when the transmitter is active. A HIGH output indicates that the
transmitter is ACTIVE.
Transmit Active
Parameter/Conditions
Min
Typ
Max
Units
V
OH
I
OH
= -100
A
2.7
2.8
Vdc
I
OH
= -4 mA
2.2
Vdc
V
OL
I
OL
= 100
A
0.1
Vdc
I
OL
= 4 mA
0.45
Vdc
6.8 Subscriber Identity Module (SIM) Carrier
The SIM, an integral part of any GSM terminal device, is a “smart card” that is programmed with subscriber
information:
The user information consists of an International Mobile Subscriber Identity (IMSI) number, which is
registered with the GSM provider, and an encryption Ki (pronounced "key"). This information
consists of a microprocessor and memory installed on a plastic card.
Note:
The SIM is not provided with the Enfora Enabler EDG0208 module. The SIM must be obtained
from the GSM service provider and must be provisioned by the operator for data and/or voice. Always
take care to protect the SIM: the GSM terminal will not operate without the SIM installed.
The SIM provides the IMSI for authentication. To gain access to the GSM network, the network
must recognize the IMSI number, and the terminal must be able to properly decrypt the data sent
by the network. The SIM also serves as a buffer for SMS messages, storing the message for
transmission until a radio link is available and buffering received messages until retrieved.
6.8.1
SIM Integration for the Enfora Enabler EDG0208 Module
The Enabler EDG0208 default configuration does not include an on-board SIM carrier. Enfora provides a
separate product SKU for the Enabler EDG0208 module with the integrated SIM carrier.
6.8.2
Using a Remote SIM with the Enfora Enabler EDG0208 Module
The Enabler EDG0208 default configuration does not include an on-board SIM carrier. If the module is
going to be integrated using a remote SIM, the following guidelines are provided:
To utilize a remote SIM, the integrator must provide a suitable SIM connector on the Application.
The maximum distance from the Enabler EDG0208 to the remote SIM connector must not exceed
25.4 cm (10 inches).
Parameter
Parameter/Conditions
MIN TYP MAX UNIT
V
DD
Supply Voltage: 1.8 V Mode + Active
1.7
1.8
1.95
Vdc
Supply Voltage: 3 V Mode + Active
2.75
2.85
3.0
Vdc
Supply Voltage: 1.8 V Mode + Sleep
1.7
1.83
1.95
Vdc
Supply Voltage: 3 V Mode + Sleep
2.75
2.9
3.1
Vdc
I
DD
1.8 or 3 V Modes
20
mA
Summary of Contents for Enabler EDG0208
Page 26: ...Integration Guide Draft EDG0208IG001 Page 21 Rev 1 03 4 19 07 Figure 11 Back of EDG0208 01 ...
Page 28: ...Integration Guide Draft EDG0208IG001 Page 23 Rev 1 03 4 19 07 Figure 13 Back of EDG0208 01 ...
Page 29: ...Integration Guide Draft EDG0208IG001 Page 24 Rev 1 03 4 19 07 Figure 14 Front of EDG0208 02 ...