Enerpac L1697, Instruction Sheet

Page: 3 / 76

• Long Jaws are available for larger capacity pullers. To change jaws, remove the ball lock
pins and slide the standard jaws out of the cage. Insert the “T” of the long jaws into the
T-slot of the cage and secure the jaws by inserting ball lock pins.
CAUTION
The rating of the puller remains the same when using the long jaws but the gripping force
is reduced by 75%. Never attempt to pry the puller by inserting anything between the jaws.
This may cause center bolt damage.
• Distortion of the jawhead assembly will occur if the bolt nut is continually forced against
the jawhead assembly. To reduce this risk, use the optional shaft protectors/ extenders
that fit over the puller’s end for tip protection and additional reach.
Note
It is impossible to predict the exact force needed for every pulling situation. The amount of
press fit and force of removal can vary greatly between jobs. The set-up requirements along
with the size, shape, and condition of the parts being pulled are variables which must be
considered.
Study each pulling application before you select your puller. Notice that a significant amount
of force can be exerted with a puller. Respect these forces and always observe all safety
precautions and warnings.
OPERATION
(3)
Figure 3
Figure 4
Figure 5