Enerpac EWCH140, Instruction Sheet

Page: 10 / 20

10
Figure 4, Locking Latch
7.0 CUTTING HEAD
7.1 Description
When closed, the cutting head prevents hand contact
with the moving piston and blade.
NOTICE:
WARNING Failure to observe and comply with the
following precautions and instructions could result
in serious personal injury.
• Always close the cutting head before beginning
the cutting process.
• Never operate cutter with cutting head open.
• Never open cutting head while cutter is operating.
Cutting head must remain closed until cutter is
stopped.
• Before reaching inside the cutting head to clear
jams or for any other reason, always stop the
pump, relieve hydraulic pressure and disconnect
pump from AC power supply.
• Always close cutting head after performing any
adjustments, maintenance or repairs.
• Be certain that cutting head is in good condition
and secured.
7.2 Opening and Closing the Cutting Head
The cutting head can be opened and closed to allow the
material to be inserted into the cutting head.
NOTICE:
WARNING Be certain that cutter is off before
opening or closing the cutting head. Serious personal
injury may result if this precaution is not observed.
To open the cutting head:
lift up on the locking latch
and swing it up and away from the cutter body as shown
in Figure 4. Then, swing the cutting head away from the
cutter body as shown in Figure 5.
To close the cutting head: swing the cutting head
toward the cutter body. Then, push down on the locking
latch to lock the cutting head in place, as shown in
Figure 6.
Figure 5, Opening the Cutting Head
Figure 6, Closing the Cutting Head