Enerpac EDCH130, Instruction Sheet

Page: 4 / 16

4
PPE Alert: Wear personal
protective equipment
(PPE) when using or
servicing equipment.
Instruction Manual Alert: Read the
instruction manual before using or servicing
equipment.
1.5 Disconnecting Pump AC Power
WARNING
Pump MUST be disconnected from the
AC power supply before performing cutter
maintenance, repair or cleaning procedures, or
before allowing persons to reach inside the shear
blades for any reason. Failure to observe this
precaution may result in serious personal injury.
• Cutter will operate immediately when pump motor is
running and the control knob is rotated.
• If it is not possible to unplug the pump power cord
from the AC power outlet, turn off and lock out
power at the AC power supply and disconnect the
hydraulic hoses.
• Refer to the separate pump instruction sheet
(provided with the pump) for detailed pump safety,
operation and maintenance instructions.
1.6 Crush Hazard
DANGER
Cutter will start immediately when
pump motor is ON and the control knob is rotated.
DO NOT place hands, fingers or other parts of
your body inside the shear blades unless pump
is disconnected from AC power supply. Death or
serious personal injury will result if cutter is operated
while persons are working inside the shear blades.
• Never reach into the shear blades while cutter is in
operation.
• Before reaching inside the shear blades for any
reason, always stop the pump, relieve hydraulic
pressure, and disconnect pump from AC power
supply.
CRUSH HAZARD
Do not reach inside shear blades
unless pump is disconnected from AC
power supply.