18
Figure 13, Fixed Blade Replacement
3
2
1
Key:
1. Safety Guard
2. Fixed Blade
3. Fixed Blade Screw
10.6.2 Blade Replacement - Fixed Blade
Replace the fixed blade as described in the following
steps. Refer to Figure 13, items 1 through 3.
1. Be sure that the cutter piston is fully retracted. If not,
start the cutter and cycle the piston until it is fully
retracted.
2. Disconnect cutter from AC power supply to prevent
accidental motor start-up during the following steps.
3. Place the cutter horizontally on a stable work surface
with the handle facing upwards.
4. Remove the fixed blade screw.
5. Open the cutter safety guard.
6. Remove the worn fixed blade and replace it with the
new fixed blade.
7.
Close the cutter safety guard approximately
10 degrees from the vertical position to gain access to
the fixed blade screw hole.
8. Secure the new fixed blade using the new fixed blade
screw included with the new fixed blade. Torque to
64 ft-lb [87 Nm].
9. Close the cutter safety guard.
10. Test cutter for proper operation before placing it
back into service.
Summary of Contents for ECCE26
Page 24: ...WWW ENERPAC COM...
