Enernet T9000, Installation And User Manual

Page: 11 / 18

January, 2005 – Operators Manual
ENERNET Corporation
8
No response will be displayed in this case. The thermostat is no
longer linked to any node. You can now install a new RCN, or press
the
SW4 MODE button to return to the normal thermostat display.
Setting Min/Max Set Point
Set point minimums and maximums may be set on the T9000 to limit
the maximum heating set point and minimum cooling set point. To
enter the min/max setup mode, you must simultaneously press the
PROGRAM and RUN buttons. Note that on four-button model
thermostats these buttons are located inside, just below the side-by-
side "SET A" batteries (see Figure 7). On seven-button
configuration models, these buttons are on the front of your
thermostat (see Figure 5). Simultaneously press the
PROGRAM
and RUN buttons, the thermostat will display the HEAT icon and set
point temperature. Use the UP or DOWN buttons to set the
maximum heating set point you wish to allow. Next, press the
HEAT/COOL button to set the Max heating temperature and bring
up the COOL icon. With the COOL icon displayed, use the UP or
DOWN buttons to set the minimum cooling setpoint temperature
you wish to allow. Simultaneously pressing the PROGRAM and
RUN buttons will take you out of the Min/Max setup mode and store
the changes you've made.
Figure 7 — Internal Button
Thermostat PCB
Micro
SW1 SW2 SW3 SW4 SW9
PB1
MODE CLK RUN PGM
SW1 – SW3 are available
inside the thermostat on the
four-button hotel model.
LINK
SET B SET B
SET A SET A