MODEL 13800 User Guide
6
INTERCONNECTION
The PSG Network Adapter is powered by the supplied 9-volt DC
wall-plug power source. A standard 9-pin serial cable connects
the PSG Network Adapter to a network interface device. (Refer to
Figure 2.)
POSITIONING
Locate the PSG Network Adapter within RF mesh network range
of one or more
EnernetWorks™
nodes to ensure sufficient
connectivity. Some installations may require the optional external
dipole antenna. (See
RF COMMUNICATION TEST
section
below.)
CONFIGURATION SWITCHES
Configuration switches set one of 256 possible network addresses
into the PSG Network Adapter in a binary fashion. See Figure 3
for Configuration Switch location and Table 1 for address setup. If
the selected network address is already in use, the Network
Adapter will light the Service LED indicating possible network
contention.
Decimal S1 S2 S3 S4 S5 S6 S7 S8
0
DN DN DN DN DN DN DN DN
1
DN DN DN DN DN DN DN UP
2
DN DN DN DN DN DN UP DN
3
DN DN DN DN DN DN UP UP
etc.
DN DN DN DN DN UP DN DN
Table - 1
MULTIPLE PSG NETWORK ADAPTERS
If multiple PSG Network Adapters are needed because of a large
number of network nodes, or in the case of two or more
independent networks comingled within overlapping RF coverage,
configuration dip switches must be set to different domain
addresses. RCN’s and any other
EnernetWorks™
capable
devices must also be set to the same network address. (See
specific device Operators Manual for details.)
