23
TEST
Yes. Correct water leak.
No. Go to step (2).
1. Is the washer leaking water?
Test 2:
8. Replace the control board.
If this did not correct the problem, go to
step 8.
7. Better models, replace the pressure sensor.
Pressure switch checks good.
Go to step (8).
Pressure switch checks bad. Replace
pressure switch.
6. Check the pressure switch.
Yes. Go to step (6).
No. Replace the inlet valve assembly.
5. Remove power from the washer. Did the water
fill stop?
Yes. Go to step (5).
No. Go to step (6).
4. Does the fill water continue enter the washer?
No. Have customer correct pressure problem.
Yes. Check for kinked or blocked incoming water
hoses, clean the incoming water screens. If
problem still remains, replace the water inlet valve
assembly.
3. Is the incoming water pressure above (30) psi.
No. Turn water faucets on.
Yes. Go to step (3).
2. Are the incoming water faucets turned on?
Yes. Go to step (4).
No. Go to step (2).
1. Is the incoming water flow normal?
Test 1:
Correction
Check
Test
mabe CONFIDENTIAL AND PROPRIETARY INFORMATION-NOT FOR PUBLIC DISCLOSURE. July 2006