Energy Save AWH11-V5+, User Manual, Page: 19 / 100

2.4 Outdoor installation
B:On a concrete stand
5
0
c
m
User can either use the dedicated mounting bracket from the supplier, or prepare a suitable bracket
for the unit installation. Make sure the installation meets following requirements:
1. The unit must be installed on flat concrete blocks, or a dedicated mounting bracket. The bracket
should be able to support at least 5 times of unit’s weight.
2. All nuts must be tightened after the bracket is fixed; otherwise,
it may cause damage to the equipment;
3.User should double check and make sure the installation
of unit is firm enough.
4. The bracket can be of stainless steel, galvanized steel,
aluminum and other materials as required by the user.
5. Besides the mounting bracket, the user can also install
the outdoor unit on two concrete blocks, or a raised concrete
platform. Please make sure that the unit is securely fastened
after installation.
6.Please refer the dimension of outdoor unit when choose a suitable wall bracket.
A:If needs to hang the outdoor unit on the wall, please do as followings:
1.Adjust the location of the wall according to the distance between two feet of the unit.
2.Fix the on the wall with expansion bolts.
3.Place the outdoor unit on the .A
4.Fix the unit to the bracket.
brackets
brackets
brackets Vibration absorbers are recommended to reduce
vibration and noise.
Bolt
Vibration absorber
Nut
Gasket
1 2 3 4
≥8°
It is recommended to use a wall sleeve
to guide power cable and piping kits go
through the wall.
Sleeve
Shield
For installation on ground where ambient temperature is below 0, use outdoor unit standings
for example the OUS35-55, in order to prevent the unit for freezing up. Concrete standings will
block the drains too much.
-18-
2.INSTALLATION