Energolux SAP24P1-A, Service Manual

Page: 15 / 46

Loosen the screw and dismount the input bar of the indoor unit; Loosen the screw and
dismount the electrical cover of the indoor unit.
Connect the power connection line to the terminal of controller board according to the
different
number
.
Wrap the wires with plastic belt refer the condition to the picture.
Fix the cables to the supporting plate for foamy shell strongly with fastening piece.
Reinstall the electrical cover with the screw.
Reinstall the input bar with screw.
The grounded wire connection:
1.loosen the grounded screw of board
2.Connect the grounded wire with the grounded screw then setscrew in the
mark formerly.
Wiring connection of Indoor Unit for SAP48/60P1-A
NOTE:
The connection mark should be agreed on for indoor unit and outdoor unit.
Don't reverse the power polarity.
The wrong connection lead to the malfunction of some electrical parts.
Must fix the screwnail of the firmly wire, then drag the wire lightly, confirmation whether it's firmly.
Must changed if the wire slide, the
self-drive
screw can't used to the electric connection.
If there is a connector, connect it directly.
1
2 N L
Cold wind Type
Terminal board for indoor unit
To power source
2
1 4 5 N L
Heat pump Type
Terminal board for indoor unit
To power source
Yellow
/Green
Indoor unit
Cover
Power wire
Board
Fastener for cable
connection
Supporting plate
for foamy shell
Input bar
Plastic strap
L1 L2 L3
N
12000W
L1 L1 L2 L2 L3 L3
N N
Yellow/
Green
To power source
Yellow
/Green
Terminal board for indoor unit
Terminal board for indoor unit
Terminal board
Connector
2 1
4 5
1
2
L1 L2 L3 N
L1 L2 L3
N
Technical Manual of Energolux
Room Air Conditioner
15