Eco 250esm / 300esm / 280i / 200p
Page
3
1. IMPORTANT
The Eco shall only be started if
the hot water cylinder is fully
filed with water.
The Eco can only function after the
respective refrigerant supply has been
connected.
The electrical input is: ~230 V, 50 Hz.
2. OPERATING PROCEDURES
Please read the following
instructions before start installing
or operating with the solar
system.
The Thermodynamic Solar System Eco shall
only be used for the heating of fresh water
and at the limits indicated on temperature
application! Heating of other liquids, such as
industrial waters or others, shall not be made
with this solar system. The technical rules
(DIN 1988) for the supply of fresh water must
be taken into account.
The thermodynamic solar panel shall be
positioned:
•
Outside;
•
In a place with good solar capture;
•
Respect fixing/fastening rules.
Positioning of the hot water cylinder must not
be done in:
•
The open air;
•
In spaces that are potentially
explosive due to vapour or liquid
gases.
Do not turn on the solar system:
•
With an empty hot water cylinder;
•
Without fluid supply (R134a).
The Eco must always be voltage free when
being worked on.
- Eco construction and assembly procedures
comply with the relevant EC
directives.
VDE, EN and IEC standards
must be complied with when
making electrical connections to the Eco.
Installation, assembly or maintenance of Eco
thermodynamic solar system may only be
carried out by qualified personnel!
2.1 PACKING, STORAGE &
TRANSPORTATION
All Energie – Thermodynamic Solar Systems
products are to be kept in the original
packaging materials and should be stored or
transported in the vertical position - note
there is an arrow to indicate the ‘UP’
direction for packing’s.
European
Certification
EN 60335-1
EN 60335-2-21
Directives
73/23/CEE
93/68/CEE
