Eco 250esm / 300esm / 280i / 200p
Page
13
between the solar panel and the
thermodynamic block. For situations that this
length is exceed is necessary to have to
make adjustments of the load. These
adjustments shall be done by the
compression pipe with the system stopped.
5.8 System Start-up
The Eco commissioning is assured by the
correct installation achieved and by the
respect of all installation instructions.
Increasing water temperature from 10° C to
55° C will vary between 4 to 8 hours,
depending on weather conditions and type of
installation.
It is always possible to do a tune of thermal
expansion valve to adapt the system to a
suitable outside weather conditions by the
temperatures extrapolation method.
Fill the hot water cylinder with water and
purge the existing air, opening a hot water
tap/faucet.
Check if the valves are properly working and
if the system is filled with fluid.
There aren’t any failure problem when
starting the system under frost conditions.
To conclude the installation process it is
necessary to connect the electrical cable to
the 230V plug socket, securing the control
panel with two M6 screws.
To turn the apparatus on, press the general
ON/OFF button (1) on the control panel.
Afterwards, press the ON/OFF button on the
Solar System (2). The display must give
information that the system is operational
(ON). Heating up of the water will now begin.
The Eco is equipped with an electrical
resistance heating process in case of any
eventual system breakdown. If it is
necessary to use this function, press the
Electrical Support (3) ON/OFF button on the
command panel and the water will be heated
via electrical resistance.
5.9 System Decommissioning
At the end of the product lifetime,
decommissioning of the system should be
undertaken by an installer or suitable
qualified plumber and / or electrician (if
required). All materials used in this product
can be passed to your local material
recycling centre for disposal - refer to local
council regulations for details.
