Energica Eva 2018, Owner'S Manual

Page: 58 / 126

57
To stop charging before the process is complete,
turn the ignition switch to ON, press
and follow the instructions on the dashboard.
If the power supply cuts out, the EVA will stop
charging and switch off.
To remove the cable from the socket, repeat the steps
described above with or without the key in the ignition
switch.
If there is an electrical failure, the cable can also be
removed from the socket manually by pressing the
metal bracket to the right of the charging socket.
If the motorcycle is not disconnected once 100% charge
is reached, the charge cycle restarts every 2 hours to
maintain maximum battery charge and ensure maximum
range.
See the paragraph "Charging the battery" for more
information on charging times and procedures.
WARNING! During charging, the battery charger
cooling fan situated in the compartment under the
seat must be kept clear of any objects which could
obstruct the air flow.
E. Rear shock absorber adjusters
Standard shock absorber
WARNING! The rear spring preload must be set
correctly for the load carried by the motorcycle.
A higher preload setting is necessary for heavier
loads, and a lower preload setting is required for
lighter loads.
To change the preload on the spring, turn the ring nut (1)
using the special tool supplied with the motorcycle.
1
EN0051
• Turn clockwise (looking from above damper) to increase
spring preload.
https://www.motomanuals.net/