3
2
Please read and understand this entire manual before attempting to assemble, operate or
install the product. Failure to do so could lead to electric shock, fire or other injuries that
could be hazardous or even fatal.
Be sure the electricity to the wires you are working on is shut off. Either remove the fuse or
turn off the circuit breaker.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This product must be installed in accordance with local, state and national electrical codes.
Installation work shall be completed by a licensed installer that is familiar with the
construction and operations of the product.
CAUTION:
The fixture body is one piece. Do not disassemble it.
This product can NOT be used with a dimmer switch.
NOTICE
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on. The
user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
•
•
•
•
•
•
•
•
-
-
-
-
1. Mark two (2) locations on mounting surface spaced
apart by 36-in.
www.energeticlighting.com
www.energeticlighting.com
Part
Item Name
Qty.
A
Fixture
1
B
Chain
2
C
“S” Hook
2
D
“J” Hook
2
E
Power Pull Chain
1
PACKAGE CONTENTS
SAFETY INFORMATION
INSTALLATION INSTRUCTIONS
Fig. 1
36-in.
Mark these two locations
on mounting surface
2. Drill pilot holes in each of the two marked locations.
Screw in the two “J” hooks (D), one in each pilot hole.
Hook one chain (B) onto each “J” hook (D).
Fig. 2
3. Insert one end of the “S” Hook (C) into the fixture
back as shown in Fig. 3, and hook the other end to
the chain to support the fixture on the mounting
surface. Repeat for the second mounting hole.
Fig. 3
A
B
C
D
Pilot holes
E
