4
This fixture is warranted to perform free from defects for five(5) years. If it fails to do so, you may
return it with proof of purchase to 13445 12th St., Chino, CA 91710 for replacement.
Clean with a mild, non-abrasive glass cleaner and soft cloth. Do NOT use solvents or clean-
ers containing abrasive agents. When cleaning the fixture, make sure the power is turned
off, and any liquid spray should be applied to the cleaning cloth and not sprayed directly onto
the fixture itself.
The fixture is powered on and off by pulling on the Power Pull Chain (E).
www.energeticlighting.com
3. Check that black, white and green wires are
extending from the back of the fixture. With the
power turned off, hold the fixture pan (A) firmly and
connect the
using wire nuts (CC). (If house wiring
does not include a ground wire, consult local
electrical code for approved grounding methods).
For proper connection, place wire nut (CC) over
wires, twisting clockwise until tight. Use wire nuts
(CC) to connect black fixture wire to black power
supply wire.
white wire from the junction box with the
white wire from the fixture pan and the green wire
from the junction box with the green wire from the
fixture pan
1-1/5in
Long Screw
2. Install two short screws (AA) into crossbar (DD)
and then secure assembly into threaded holes on
junction box (not included) tightly. Install two long
screws (BB) into the crossbar (DD), leaving
approximately 1-1/5 in. out.
INSTALLATION INSTRUCTIONS
CARE AND MAINTENANCE
OPERATING INSTRUCTIONS
TROUBLESHOOTING
WARRANTY
Problem
Possible Solution
Corrective Action
Fixture does not light.
Power is off.
Check circuit breaker
or wall switch.
4. After mounting the fixture plug the power cord into a
grounded outlet to finish the installation.
Fig. 4
