WARNING
To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or
other sharp objects.
Do not make or alter any open holes in an enclosure of wiring or electrical components
during kit installation.
Verify that supply voltage is correct by comparing it with the luminaire label information.
All wiring connections should be capped with UL approved wire connectors.
Minimum 90°C supply conductors.
Suitable for Damp locations.
Suitable for Type IC installation.
3
2
•
•
•
•
•
•
•
Please read and understand this entire manual before attempting to assemble, operate or
install the product. Failure to do so could lead to electric shock, fire or other injuries that
could be hazardous or even fatal.
Be sure the electricity to the wires you are working on is shut off. Either remove the fuse or
turn off the circuit breaker.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
CAUTION:
This product can only be dimmed with a 0-10 Volt dimming system.
NOTICE
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on. The
user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
This Class B digital apparatus complies with Canadian ICtES-003.
Before beginning assembly of product, make sure all parts are present. Compare parts with
package contents list and hardware contents list. If any part is missing or damaged, do not
attempt to assemble the product.
Estimated Assembly Time:
20 minutes
•
•
•
•
•
-
-
-
-
•
1. Ensure that the power to existing fixture has been
shut off before proceeding with the installation of this
retrofit kit.
Remove from the existing troffer the lens or louver,
hinged frame, all fluorescent lamps, wiring/ballast
compartment cover, ballast, lampholder sockets and
rail.
1
www.energeticlighting.com
www.energeticlighting.com
A
B
C
D
A
D
Retrofit assembly
Wire nuts
1
B
Bracket
2
C
Sheet metal screw
4
5
Part
Item Name
Qty.
PACKAGE CONTENTS
SAFETY INFORMATION
SAFETY INFORMATION
PREPARATION
INSTALLATION INSTRUCTIONS