16
17
Operation
GB
IE
GB
IE
In more detail...
ENB522TCB by
Energer
ENB522TCB by
Energer
In more detail...
Operation
To cut 45° angles, place the two lower 45° mitre stays on the lid supports
into the two slots located inside the water reservoir. Place the piece of tile
facing down onto the water reservoir lid then push the work piece towards
the diamond wheel.
Loosen the cutting guide knobs at both ends of the cutting guide.
Set the cutting guide to the distance required. Relock the cutting
guide knobs.
Hook the angle guide onto the cutting guide.
Choose the angle desired and tighten the bolt to secure the angle
guide in conjunction with the cutting guide.
Push the angle guide together with the tile to be cut towards the
diamond wheel. (refer to pic.2)
>
Diagonal cuts
Straight cuts
Loosen the cutting guide knobs at both ends of the cutting guide.
Set the cutting guide to the desired size using the ruler guide.
Relock cutting guide knobs.
Place the piece of tile against the cutting guide then push the
work piece towards the diamond wheel. (refer to pic.1)
2.
You can extend the extension table to support larger tiles when these
are being cut.
Filling the water tank
> Before cutting, the tank must be filled with water:
Fill two-thirds of the tray of cold and clear water. The water can cool
and lubricate the disk during the cut and it also helps to remove dust.
WARNING! Do not add chemicals or detergents
to the water.
> Lift up the water reservoir lid
Pull out the two lid supports located on the back of the water
reservoir lid.
To cut 22.5° angles, place the two upper 22.5° mitre stays on the
lid supports into the two slots located inside the water reservoir.
>
Mitre Cuts
pic.1
pic.2
WARNING! Clean the water tank after 15min working.
