Getting
FR
IE
Getting
started...
12
13
GB
IE
GB
IE
Getting started...
Getting started...
ENB522TCB by
Energer
ENB522TCB by
Energer
Before you start
Before you start
Install the diamond wheel
1. Lift the water reservoir lid up to remove by bending the two pivot
tabs at the front and back.
2. Remove the splash guard by releasing the screw.
Loosen the locking nut whilst holding the spindle in place with the supplied
spanners.
Remove the locking nut and the outer flange.
Fit the diamond wheel onto the inner flange noting the rotation direction on the
diamond wheel. The direction arrows on the diamond wheel must be in the
same direction as that marked on the wheel guard, or as that indicated around
the spindle.
Ensure that the diamond wheel is fully located and centred.
Replace the outer flange ensuring that the flat side of the flange is against the
diamond wheel; firmly tighten the locking nut using the spanners provided.
Install the accessories
Install the guide
ON/OFF Switch
> Secure the guard fixing bracket to the cutting table using the
supplied screw. Secure the wheel guard to the fixing bracket
using the bolt and lock nut.
1
> Locate the cutting guide to seat over the cutting guider at the front
and back of the cutting table.
> Fit cutting guide knobs (1).
> Tighten the cutting guide knobs to clamp the cutting guide to the
edge of the cutting table.
> The saw can be switched on by pressing the green pushbutton “I”.
> The red pushbutton “0” has to be pressed to switch off the saw.