Enerdrive ePRO COMBI Owners Manual
Page 20
All mode indicator LEDs
‘inverter on’, ‘charger on’ and
‘AC in’ are blinking red twice
per second (manual reset
needed)
Maximum AC transfer switch
current has been exceeded.
Reduce the AC output load
Mode indicator LED ‘inverter
on’ or ‘charger on’ or ‘AC in’ is
red continuously.
Either the inverter mode,
or the charger mode or the
AC transfer switch has been
disabled using Dashboard.
Enable again using Dashboard if required.
If only ‘inverter on’ is red
continuously.
ePRO Combi main switch is put into
‘charger only’ mode, meaning that the
inverter is disabled.
Output power bar is red
(inverter mode).
The inverter is overloaded
and will shut down after a
certain time (depending on
the amount of overload)
Reduce the AC output load
All mode indicator LEDs
‘inverter on’, ‘charger on’ and
‘AC in’ are blinking red four
times.
Device or connection fault.
ePRO Combi is defective, return for
service.
External AC source is connected to the AC
output instead of the AC input.
Mode indicator LED ‘charger
on’ blinks five times.
Charge program error.
User has selected an empty or invalid
charge program (‘custom’ charge program
is empty from factory).
Advanced user made charge program
contains ‘go-to error’ condition, for
example when a charge stage takes too
much time.
If none of the above remedies will help solving the problem you encounter, it’s best to contact your local
Enerdrive distributor for further help and/or possible repair of your ePRO Combi. Do not disassemble the ePRO
Combi yourselves, there are dangerously high voltages present inside and will also void your warranty.
