A press of “ENTER” made at previous step gives access to set the resolution of the
display, after the 2s flag indication shown in figure 22.1 (dCP). Available options are
"1" = reading without decimal point and "0.1" = reading with one decimal place.
Press
if wanted to change the option present on the display. Press
ENTER
to
save the entry and return to the run mode.
To have access to the programming of the sampling and limit times (see page 20),
hold down the
ENTER
key for 3 seconds, at the end of which the indication shown on
next figure appears on the display.
The sampling time (two digits with a decimal place, see page 20) is present on the
display after the symbol shown in figure 22.2.
Use the
and
procedure to modify the initially programmed value (from
0.1 to 9.9 seconds). Press
ENTER
to validate the entry and pass to the limit time
programming phase.
A press of “ENTER” made at previous step makes the display show the symbol
corresponding to the limit time program step (see figure 22.3) followed, after 2s by
the previously programmed numerical value with the first of its two digits in flash.
Use the
and
procedure to modify the initially programmed value (from 1
to 10 seconds). Press
ENTER
to validate the entry and automatically return to the
normal operation.
4
20
[22.1] Resolution
UP
SHIFT
DATA
ENTER
1
2
[22.2] Sampling time
UP
SHIFT
DATA
ENTER
1
2
[22.3] Limit time
UP
SHIFT
DATA
ENTER
1
2
FRONT-PANEL FUNCTIONS DESCRIPTION (RUN MODE)
LED SET1
Indicates setpoint 1 status.
KEY UP
Disabled in run mode.
DISPLAY
Displays the variable being measured.
KEYBOARD IN RUN MODE
LABEL
Engineering units.
KEY DATA
Shows programming data.
Gives access to PROG mode.
KEY SHIFT
Disabled in run mode.
LED SET2
Indicates setpoint 2 status.
UP
SHIFT
DATA
ENTER
1
2
