Enerblue PURPLE, User And Maintenance Manual

Page: 7 / 40

USER and
MAINTENANCE
MANUAL
7
Failure to comply with the instructions in this manual and any modification to the unit without written
consent, will immediately render the warranty and conformity null and void�
Any intervention on the unit must be performed by qualified personnel.
Warning: before performing any intervention on the unit make sure
that the power supply has been disconnected. Refer to the section on
maintenance.
3.1 OVERVIEW
Upon installation or whenever interventions must be performed on the refrigeration unit, it is essential
to carefully follow the instructions in this manual, comply with the indications shown on board the unit
and apply all precautions required�
The pressures in the hydraulic circuit and the electrical components can create risky situations during
installation and maintenance interventions�
INSPECTION, UNPACKING, TRANSPORT
Below is a description of the main symbols used in this manual and on the labels affixed on the unit�
4.1 INSPECTION
Check the unit upon receipt, bearing in mind that it left the factory in perfect condition; report any signs of
damage immediately to the transporter and make a note of these on the Delivery Sheet before signing it�
The commercial office or manufacturer should be informed of the extent of the damage as soon as
possible� The Customer must fill in a written and photographic report concerning any relevant damage�
4.2 UNPACKING
Disposal of packing material is the responsibility of the receiver and must be carried out in compliance
with local and national regulations�
4.3 LIFTING AND TRANSPORT
During unloading and positioning of the unit, great care must be given to prevent sudden or violent
manoeuvres and not using machine components as strong points� Lift the unit using steel tubes inserted
in the relative lifting holes� The unit must be lifted by harnessing it as indicated in figure 1� Use cords or
belts that are long enough and spacer bars so as not to damage the sides and lid of the unit� Alternatively,
the units can be lifted using a fork-lift truck, inserting the forks in the supporting pallet (fig� 1)�
4
Attention: In all lifting operations, make sure that the unit is fastened
well in order to prevent accidental falls or over-turning.