２７
• VIEW ANGLE SETUP
FLIP
: OFF,90
°
,100
°
,110
°
,120
°
,AUTO
OFF:
the dome camera moves until 90
°
vertically.
90
°
, 100
°
, 110
°
, 120
°
:
allows the image to flip digitally when the camera moves over the
setting angle vertically.
AUTO:
When the camera reaches the floor directly above the moving object, it will stop. At
that time, release the
Joystick
handle instantly and pull it down again to run the auto-flip
function. When you use the panning range, we recommend using the flip mode to AUTO.
TILT OVER ANGLE:
This option is used to set the limit of the horizontal view angle so that the trim ring or ceiling
does not obstruct the horizontal image when zooming out (wide angle).
ON:
In some installations it is desirable for the dome camera to be able to see above the
horizon. When this option is chosen, the dome will tilt up over the horizon (About -10 degrees).
When the lens is zoomed out, you can see the ceiling line. But when the lens is zoomed in, the
viewing angle is narrower, and the ceiling line disappears.
OFF:
The tilt range of the camera is limited to see the horizon so the picture shows part of the
ceiling line.
Over Angle is not sufficient enough to avoid ceiling obstructions, please adjust Origin Offset of
tilt angle as described below.
PANNING RANGE
When the dome camera is installed near a wall, panning range can be limited by user.
1. Place the dome camera under 90 degree vertically.
2. Set the right limit by pushing the
Joystick
to the right.
3. Set the left limit by pushing the
Joystick
to the left.
4. Set ENABLE to ON to use
To exchange the right and the left limit, set SWAP to ON.
To apply limits on the auto pan (endless panning), set AUTO PAN to ON.
NOTE: When the flip mode is 90
°
, 100
°
, 110
°
or 120
°
and you moves over 90
°
vertically, the panning
range operates in opposite side.
VIEW ANGLE SETUP
PANNING RANGE
FLIP
: 90
°
TILT OVER ANGLE : ON
SAVE AND EXIT(ESC TO CANCEL)
PANNING RANGE SETUP
(CTRL KEY)
RIGHT LIMIT : 000.0
LEFT LIMIT : 000.0
ENABLE : OFF
SWAP : OFF
AUTO PAN : OFF
SAVE AND EXIT(ESC TO CANCEL)
Summary of Contents for EDCH/143E/C
Page 1: ...ALL IN ONE DOME CAMERA EDCH 143E C Instruction Manual...
Page 43: ......
