Operating Instructions
18
Highlight the
LAN
tab, and the LAN screen displays.
Figure 19 — LAN (Manual) setup screen.
Highlight the box beside
Type
and press the button. You
can select the type of network configuration from:
Manual
,
DHCP
and
ADSL (with PPPoE)
. Select the desired type
and press the button.
Selecting
Manual
from the Type allows you to set up LAN
parameters manually.
Change the numbers by highlighting them and using the
Up
and
Down
arrow buttons to increase or decrease the number.
The factory default LAN settings are:
IP
Address: 192.168.1.129
Gateway:
192.168.1.254
Subnet
Mask:
255.255.255.0
NOTE: You will need to get the appropriate IP Address, Gateway and Subnet Mask from your network
administrator.
Highlight the box beside
DNS Server
. Press the
Up
and
Down
arrow buttons to set the IP address of the DNS server.
Highlight the
Port Number Setup…
box and press the button. The
Port Number Setup
screen appears.
NOTE: You will need to get the appropriate Port Numbers for each RAS and WebGuard related program (Admin,
Callback, Watch and Search) from your network administrator.
Change the numbers by highlighting them and using the
Up
and
Down
arrow
buttons to increase or decrease the number. The factory default Port settings are:
Remote Admin:
8200
Remote
Callback: 8201
Remote Watch:
8016
Remote
Search:
10019
NOTE: The system restarts automatically after changing the port settings.
Do NOT use the same port number for two different programs, otherwise, the DVR cannot be connected
with the PC running RAS or WebGuard.
CAUTION: When changing the port settings, you must change the port settings on the PC running
RAS or WebGuard as well. Refer to the RAS manual for details.
Selecting
DHCP
from the Type and highlighting
Save
button
reads the current IP address of the DVR configured by DHCP
(Dynamic Host Configuration Protocol) network.